Iranian Journal of Wood and Paper Industries

Iranian Journal of Wood and Paper Industries

Influence of using native starch through modification with α-amylase enzyme for surface paper sizing as an alternative to oxidized starch

Document Type : Research Paper

Authors
Pejman Rezayati Charani 1
Sonia Kalantari Charvadeh 2
Ahmad Azizi Mossello 2
1 Wood and Paper Industries, Faculty of Natural Resources, Behbahan Khatam Alanbia University of Technology, Behbahan, Iran.
2 Department of Cellulose Technology Engineering, Natural resources faculty, Behbahan Khatam Alanbia University of Technology, Behbahan, Iran
Abstract
This study aimed to the native starch modification with α-amylase enzyme and compare it with oxidized starch for surface sizing of paper. Native starch was prepared under different temperature and time conditions by addition of alpha-amylase enzyme to achieve viscosity proportional to oxide starch for base paper surface sizing. Then, the basic industrial paper was subjected to surface sizing by immersion with enzymatic starch and oxidized starch prepared. The papers physical and mechanical properties were measured and evaluated after drying. Based on the results of this study, oxidized starch viscosity at a concentration of 5 % at 95 °C reached 17.51 cp during preparation and to achieve this amount of enzymatic starch viscosity, native starch was prepared at 85 °C using 0.005 % enzyme. The results also showed starch modification with the enzyme by varying the temperature, cooking duration, and concentration of the enzyme and native starch, it is possible to achieve a spectrum of viscosity. Evaluation of the physical and mechanical properties showed greater improvement in paper properties including indices of transverse and longitudinal tensile strength (20% and 30% respectively), transverse and longitudinal tear strength (7% and 15% respectively), burst strength (15%), CMT (7%), and RCT (30%) using enzymatic modified starch compared to oxidized starch for surface sizing. In general, the use of α-amylase enzyme in comparison with oxidized starch enables the economical preparation of starch with a spectrum of viscosity for different conditions for a certain improvement in paper properties can be considered for industrial application.
Keywords
Industrial Paper
Oxidized Starch
α-Amylase
Surface sizing
Physical and Mechanical Properties

Subjects

  • Ezeudu, O.B., Agunwamba, J.C., Ezeasor, I.C. and Madu, C.N., 2019. Sustainable production and consumption of paper and paper products in Nigeria: a Resources, 8(1):53.
  • Kamali, M., Alavi-Borazjani, S.A., Khodaparast, Z., Khalaj, M., Jahanshahi, A., Costa, E. and Capela, I., 2019. Additive and additive-free treatment technologies for pulp and paper mill effluents: Advances, challenges and opportunities. Water Resources and Industry, 21:100109.
  • Ghosh, D., Saha, B., Singh, B.J.I.E.A., 2019. Enzymes for Pulp and Paper Applications. In: Industrial Enzyme Applications (pp. 287-321), Wiley-VCH. Verlag GmbH and Co. KGaA, Boschstr. Weinheim, Germany.
  • Singh, G., Kaur, S., Khatri, M. and Arya, S.K., 2019. Biobleaching for pulp and paper industry in India: Emerging enzyme technology. Biocatalysis and agricultural biotechnology, 17:558-565.
  • Irfan, M., Ghazanfar, M., Rehman, A.U. and Siddique, A., 2019. Strategies to Reuse Cellulase: Immobilization of Enzymes (Part II). In:  Approaches to Enhance Industrial Production of Fungal Cellulases (pp. 137-151). Springer, Cham.
  • Tripathi, S., Verma, P., Mishra, O.P., Sharma, N., Bhardwaj, N.K. and Tandon, R., 2019. Reduction in Refining Energy and Improvement in Pulp Freeness through Enzymatic Treatment–Lab and Plant Scale Studies. Journal of Scientific and Research, 78(01):50-54.
  • Tan, Z., FOSTER III, C.A. and Pelletier, J.R., Basf Se, 2019. Methods of Modifying Pulp Comprising Cellulase Enzymes and Products Thereof. U.S. Patent Application 16/332,284.
  • Ballinas-Casarrubias, L., González-Sánchez, G., Eguiarte-Franco, S., Siqueiros-Cendon, T., Flores-Gallardo, S., Duarte-Villa, E., De Dios-Hernandez, M., Rocha-Gutiérrez, B. and Rascon-Cruz, Q., 2019. Chemical Characterization and Enzymatic Control of Stickies in Kraft Paper Production. Polymers, 12(1): 245.
  • Kumar, N.V., Rani, M.E., 2019. Microbial enzymes in paper and pulp industries for bioleaching application. Research Trends of Microbiology, 1-11.
  • Ali, M. and Sreekrishnan, T.R., 2001. Aquatic toxicity from pulp and paper mill effluents: a review. Advances in environmental research, 5(2):175-196.
  • Hashim, S.O., 2019. Starch-Modifying Enzymes. In: Advances in Biochemical Engineering/ Biotechnology (pp. 221-244). Springer, Berlin, Heidelberg.
  • Yujuan, Z., Shengtao, M., Jingjing, W., Hongqi, D., 2013. Preparation of enzymatic starch modified by TEMPO oxidation and its application on surface sizing. Journal of Nanjing Forestry University (Natural Sciences Edition), 37(1):111-116.
  • Maurer, H.W., 2001. Enzyme conversion of starch for paper sizing and coating. Starch and starch products in surface sizing and paper coating. Tappi, Atlanta, GA, 65.
  • Yakubu, A., Saikia, U. and Vyas, A., 2019. Microbial Enzymes and Their Application in Pulp and Paper Industry. In Recent Advancement in White Biotechnology Through Fungi (pp. 297-317). Springer, Cham.
  • Saffarzadeh, A., 2015. GAW technologies GmbH report number O0037020 Pars paper industries, Iran.
  • Bajpai, P., 2018. Enzymatic Modification of Starch for Surface Sizing. In: Biotechnology for Pulp and Paper Processing (pp. 431-442). Springer, Singapore.
  • Singh, J., Kaur, L., McCarthy, O.J., 2007. Factors influencing the physico-chemical, morphological, thermal and rheological properties of some chemically modified starches for food applications—A review. Food Hydrocolloids, 21(5):1-22.
  • Meimoun, J., Wiatz, V., Saint‐Loup, R., Parcq, J., Favrelle, A., Bonnet, F. and Zinck, P., 2018. Modification of starch by graft copolymerization. Starch‐Stärke, 70(1-2):1600351.
  • Maurer, H.W., 2001. Starch and starch products in surface sizing and paper coating. Tappi Press.
  • Kraus, J.K. and Hebeda, R.E., Unilever Bestfoods North America, 1993. Method for retarding staling of baked goods. U.S. Patent 5,209,938.
  • Goodarzi, V., Jafari, S.H., Khonakdar, H.A. and Seyfi, J., 2011. Morphology, rheology and dynamic mechanical properties of PP/EVA/clay nanocomposites. Journal of Polymer Research, 18(5):1829-1839.
  • Shirazi, M., Esmail, N., Garnier, G. and Van de Ven, T.G.M., 2005. Starch penetration into paper in a size press. Journal of dispersion science and technology, 25(6):457-468.
  • Rezayati Charani, P., Azizi mossello, A., and Kalantari Charvadeh, S.,2019. Paper surface sizing by Starch Modified with Alpha-Amylase: a review. Journal of Environmental Science Studies, 4(6):2063-2073.
  • Gülsoy, S., Hürfikir, Z., Turgut, B., 2016. Effects of decreasing grammage on the handsheet properties of unbeaten and beaten kraft pulps. Türkiye Ormancılık Dergisi, 17(5):56-60.
  • Navaranjan, N., Dickson, A., Paitakari, J. and Iimonen, K., 2013. Humidity effect on compressive deformation and failure of recycled and virgin layered corrugated paperboard structures. Composites Part B: Engineering,  45(5): 965-971.
  • Mattsson, R., 2002. AKD sizing: dispersion colloidal stability, spreading and sizing with pre-flocculated dispersion (Doctoral dissertation, Luleå tekniska universitet). p. 34.
  • Bildik, A.E., Hubbe, M.A. and Gurboy, K.B., 2016. Alkyl ketene dimer [7] sizing of paper under simplified treatment conditions. Tappi Journal, 15(8):545-552.
  • Faidiy, Y., Mobarak, F., Augustin, H., 1972. Influence of starch addition on filler retention and paper properties of straw and wood pulps. Cellulose Chemistry and Technology, 6: 67-70.
  • Lee, H.L., Shin, J.Y., Koh, C.H., Ryu, H., Lee, D.J. and Sohn, C., 2002. Surface sizing with cationic starch: Its effect on paper quality and papermaking process. Tappi Journal, 1(5):34-40.
  • Ghasemian, A., Ghaffari, M. and Ashori, A., 2012. Strength-enhancing effect of cationic starch on mixed recycled and virgin pulps. Carbohydrate Polymers, 87(2):1269-1274.

[31]  Borodulina, S., Motamedian, H.R., Kulachenko, A., 2016. Effect of fiber and bond strength variations on the tensile stiffness and strength of fiber networks. International Journal of Solids and Structures,154:19-32.

  • Larsson, P.T., Lindström, T., Carlsson, L.A. and Fellers, C., 2018. Fiber length and bonding effects on tensile strength and toughness of kraft paper. Journal of materials science, 53(6):3006-3015.
  • Page, D. and MacLeod, J.M., 1992. Fiber strength and its impact on tear strength. Tappi Journal, 75(5): 172-174.
  • Rezayati-Charani, P. and Mohammadi-Rovshandeh, J., 2005. Effect of pulping variables with dimethyl formamide on the characteristics of bagasse-fiber. Bioresource Technology, 96(15):1658-1669.
  • Zeydi, F.B., Atoii, G.A., Ramezani, O., Nazarnezhad, N., 2014. Optimum Consumption Levels of China Clay and GCC in Mixed NSSC/OCC Fluting Paper. Lignocellulose, 3(2):169-175.
  • Shi, B., Mleziva, M.M., Thompson, B.M. and Zelenak, R.J., Kimberly Clark Worldwide Inc, 2017. Hybrid fiber compositions and uses in containerboard packaging. U.S. Patent 9,816,233.

Ochoa de Alda, J.A.G., 2008. Feasibility of recycling pulp and paper 

Iranian Journal of Wood and Paper Industries
Volume 11, Issue 3
Autumn 2020
Pages 433-443