[1] Ebrahimi, G., 2007. Engineering design of furniture structure, Tehran university publication 491p.
[2] Eckelman, C. A., 2003. Textbook of product engineering and strength design of furniture, West Lafayette (IN), Purdue University Press.
[3] Jones, A., and Lutes, R., 1993. Handbook of joinery, New York, USA, Sterling Press.
[4] Zhang, J. L., and Eckelman, C. A., 1993. The bending moment resistance of single–dowel corner joints in case construction, Forest Products Journal 43(6): 19–24.
[5] Kurt, S., Uysal, B., Ozcan, C., and Yildirim, M.N., 2009. The effects of edge banding thickness of Uludag Fir bonded with some adhesives on withdrawal strengths of Beech dowel pins in composite materials, BioResources 4(4): 1682-1693.
[6] Norvydas, V., Juodeikiene, I., and Minelga, D., 2005. The influence of glued dowel joints construction on the bending moment resistance, Materials Science 11(1): 36-39.
[7] Bahmani, M., Ebrahimi, G., and Fathi, L., 2009. Predicting of withdrawal strength with dowel joint in medium density fiber (MDF) by mathematic model, Iranian Journal of wood and Paper Science Research 24(1): 117-124.
[8] Jahan Latibari, A., Ghofrani, M., and Noori, H., 2005. Investigation the holding strength of dowel joint constructed of particleboard, Iranian Journal of Agricultural Sciences 11(1): 135-148.
[9] Dalvand M, Ebrahimi G.H., Rostampour Haftkhani A., and Maleki S., 2013. Analysis of factors affecting diagonal tension and compression capacity of corner joints in furniture frame fabricated with dovetail key, Journal of Forestry Research 24(1): 155−168.
[10] Derikvand, M., Smardzewski, J., Ebrahimi, G.H., Dalvand, M., and Maleki, S., 2013. Withdrawal force capacity of mortise and loose tenon T-type furniture joints, Turkish Journal of Agriculture & Forestry 37: 377-384.
[11] Standard Test Methods for Small Clear Specimens of Timber. Annual Book of ASTM Standard, D 143, 2000.
[12] Standard Test Methods for Specific Gravity of Wood and Wood–Base Materials, Annual Book of ASTM Standard, D 143, 2000.
[13] Heydari, H., 2011. Fabricating a wooden bearing for combine and evaluating its functionality. MS.C Thesis, Department of wood and paper Science and Technology Faculty of Nature Resource, University of Tehran.
[14] Eckelman, C. A., 2004. Engineering design of furniture, Purdue University USA, Chap 6.
)