Study on Influensive Factors on Surface Quality and Edges of Through- Holes Bored in Particleboard and MDF

Document Type : Research Paper

Authors

Abstract

In this research, effects of different factors in the CNC machine through- Hole boring of MDF and particleboard were investigated. Variables in boring were selected bit diameter in 3 levels 5,10 and 15 mm, feed speed in 2 levels 0.3 m/min and 0.6 m/min and rotary speed of machine axis in 3 levels 300,1500 and 3000 rmp. The goal of this study was to measure effects of mentioned factors on edge- quality of through- holes made in particle- board and MDF. Results have shown that with all bit diameters used, increasing rotary speed of bit improves smoothness of holes in both sides and boring dusts turned to finer sizes. Increasing feed speed did show positive effect on edge surface quality and lowered burr formation.
 

Keywords

References

1- دوست حسینی، کاظم، 1380، فناوری تولید و کاربرد صفحات فشرده چوبی– جلد اول، شماره انتشار 2478، انتشارات دانشگاه تهران، صفحه 519.
2- مجله شانزدهمین نمایشگاه بین المللی مبلمان ایران ( MEDEX 2006 )، صفحات 11-1.
3- Banshoya K (2005) Burr Formation in Machine Through- Hole Boring of Wood-Based Materials With Through- Type Bit, Proceeding IWMS 17- Rosenheim, Germany: 374-384.
4- Banshoya K (1986) Tool Life in Machine Boring of Wood and Wood Based Materials.VI. Machinability of various domestic and imported wood species. Mokuzai Gakkaishi, 32: 418-424.
5- Banshoya K, Mori M (1980) Tool Life in Machine Boring of Wood and Wood Based Materials. I. Effect of spindle speed of spur machine bit. Mokuzai Gakkaishi, 26: 74-80.
6- Juan J., (1992). Comment Bien Usiner Le Bois. CTBA (140) :P 37-65.
7- Khazaeian A., (2005) Caracterisation 3D de l'etat de surface du bas : Sterategie de mesure influence de paramètres liès à l'éssence et à l'usinage. thèse unversité d'ENGREF,  IUT de Tarbes :, 241 p.
8- Komatsu M (1979) Machine Boring Properties of Wood. X. The effect of the grain angle of wood on the cutting accuracy of twist drill.  Mokuzai Gakkaishi, 25: 573-581.
9- Komatsu M (1979) Machine Boring Properties of Wood. IX. The effect of the grain angle of wood on the cutting force of twist drill.  Mokuzai Gakkaishi, 25: 573-58.
10- Komatsu M (1978) Machine Boring Properties of Wood. VI. The effect of the point angle of twist drill on the accuracy of finishing.  Mokuzai Gakkaishi, 22: 491-497.
11- Momoi T, and et al. (2005) Evaluation of Machined Surface by the Machine-Boring at Cellular Level. (University of Tokyo Faculty of Regional Environment Science).Setagaya-Ku Tokyo 156-8502 Japan.    
12- WWW.WICKIPEDIA.COM

Files

Share

How to cite

Statistics