The Investigation of Acoustic Properties of Carbon Fiber-Polyester Composites and Comparing the Results with Poplar, Walnut and Beech Wood Specimens

Document Type : Research Paper

Authors

Abstract

In this paper, regarding the high capability of polymeric composites as a substitute of the wood in musical instruments, the acoustic properties of carbon fiber-polyester composites, such as elastic modulus, acoustic coefficient, acoustic coefficient efficiency etc, were investigated using free longitudinal and flexural vibration non-destructive tests and forced vibration non-destructive test. For better understanding, three wooden samples of poplar, walnut and beech trees (frequently used in the manufacturing of musical instruments) were chosen and analyzed. Comparing the results showed that the resultant composites had essential acoustic and vibrational properties higher than those of wood samples. Ultrasonic velocity and elastic modulus in longitudinal direction of carbon composites were approximately 11300 m/s and 130GPa, respectively. Besides, the damping results of carbon composites are magnificent and far better than those of the wood specimens.
 

Keywords

References

1- Rujinirun, C., Phinyocheep, P., Prachyabrued, W. and Laemsak, N., 2005. Chemical treatment of wood for musical instruments. Part I: acoustically important properties of wood for the Ranad, Wood Science and Technology 39(1).
2- Mousavi, S.Y. and Pirayeshfar, A.S., 2008. Polymeric composites for music, Honar quartery 75: 280-296(In persian).
3- Pirayeshfar, A.S. and Mousavi, S.Y., 2009. A study on acoustic properties of fiber composites based on Epoxy resin. Honar quarterly 79: 204-214(In persian).
 
4- Graphite/epoxy composite violin. Composites. 12(3).
5- Pedgley, O., Norman, E. and Armstrong. R., 2009. Materials-inspired innovation for acoustic guitar design. Journal of METU JFA, 26(1): 157-175.
6- Janes, R. and Cumpiano, W.R., 2004. Compression molded composite guitar soundboard. US Patent 5333527.
7- Davis, S.J., Janes, R., Bash, C.M. and Chou, P.J.C., 1994. One piece composite guitar body. US Patent 6,683,236 B2
8- Brydson, G.E., Translated by Omidian, H., Plastics Materials. Iran University Press, 1380.
9- www.wikipedia.com
10- Tavana, H., 1998. Human made fibers, Arkan Persian_ion, Tehran. Iran (In Persian).
11- Shaffer, J., Philippidis, T.P. and Vassilopoulos, A.P., 2004. Handbook of Advanced Materials Edited by J.K. Wessel. Chapter1. ISBN 0-471-45475-3, John Wiley & Sons, Inc.
12- Roohnia, M., 2005. Study on Some Factors Affecting Acoustic Coefficient and Damping Properties of Wood Using Nondestructive Tests, Ph.D. Thesis, Islamic Azad University Campus of Science and Researches.
13- Madjidi-zolbanine, H., 1991. Vibrations and waves, Elm va Sanaat university publication, Tehran, Iran (In Persian).
14- Brancheriau, L. and Bailleres, H., 2002. Natural vibration analysis of clear wooden beams:a theoretical review. Wood Science and Technology, Springer-Verlag.
15- Tita, V., Carvalho, J.D. and Lirani, J., 2001. A Procedure to Estimate the Dynamic Damped Behavior of Fiber Reinforced Composite Beams Submitted to Flexural Vibrations. Materials Research 4(4): 315-321.
16- Chandra, R., Singh, S.P. and Gupta, K., 2003. Prediction of Damping in Three-phase Fiber-reinforced Composites, Defence Science Journal 53(3): 325-337.
17- Bordonne, P.A., 1989. Module dynamique et frottement interieur dans le bois: Mesures sur pouters flottantes en vibrations naturelles. These de doctorat de I’INP de Lorraine soutenue a Nancy. Page 154.
18- Roohnia, M., Tajdini, A., 2008. Investigation on the possibility of modulus elasticity and damping factor measurements, in timbers from Arizona cypress using free vibration NDT in comparison with static bending and forced vibration NDT, Journal of Agricultural Sciences Islamic Azad University 13(4):1017-1028(In Persian).
19- Roohnia, M., Doost Hosseini, K., Khademi Eslam, H., Grill, J., A Study on Variations of Specific Modulus of Elasticity  and shear moduluses of Arizona cypress wood using non destructive vibrational test. Iranian Journal of Natural Resources. 59: 921-932.
20- Roohnia, M., Behnam, B., Hossein, M.A., Alavi-tabar, S.E., Tajdini, A., Manouchehri, N., 2009. Evaluating the dynamic of elasticity of Arizona cypress wood using Iranian forced vibration system. Accepted in Natural Resources Science and technology magazine (In persian).
21- Standard test method for dynamic Young’s modulus, shear modulus and Poisson’s ratio of refractory materials by impulse excitation of vibration, designation, Annual book of ASTM standard, C1548.
Iranian Journal of Wood and Paper Industries
Volume 1, Issue 2 - Serial Number 2
December 2011
Pages 83-101

Files

Share

How to cite

Statistics